Donnerstag, 2. Oktober 2025

Halloween-Karte nur mit Stanzteilen


 Hallo Ihr Lieben!
Wie der Posttitel schon verrät habe ich heute eine Halloween-Karte für Euch, die, bis auf den Text, nur mit Stanzteilen gemacht ist. Ich hatte da noch einige Sets aus dem August-Release von LawnFawn unbenutzt auf dem Tisch. Und bevor die Spukzeit rum ist, wollten die natürlich noch verwendet werden!
 
Hello everyone! 
Today I have a Halloween card, that I created only using die cuts - except for the text. I still had some sets from LawnFawn's august release unused on my table. And before spooky season is over, those wanted to be used.
 
Ach, ein Stencil kam auch noch zum Einsatz, nämlich für den Mond. Ich habe den Nightsky Stencil von LawnFawn verwendet und erst den Mond ganz leicht mit Distress Ink Scattered Straw gewischt. Die Krater habe ich dann mit Pumice Stone gemacht und von dem Pumice Stone anschließend ganz wenig noch auf den Rest des Monds aufgetragen. Das macht ihn nicht nur weniger gelb, sondern auch die Ränder der Krater etwas softer.
Den Himmel drumherum habe ich dann mit Distress Ink Fossilized Amber, Crackling Campfire, Fired Brick und Ground Espresso gemacht. Nun, ganz ehrlich, das sah mir ein wenig zu sehr nach Sonnenuntergang am Meer aus. Also habe ich auch noch etwas Black Soot hinzugefügt. Dann habe ich erst einige Wassertropfen und anschließend schwarze Acrylfarbe aufgespritzt. So ist der Himmel dann defnitiv halloween-ig genug für mich. 
 
Oh, I also used a stencil to create the moon. I made it with the Nightsky stencil by LawnFawn and created the moon first by inking it on with just a  bit of Distress Ink Scattered Straw. I added the craters with Pumice Stone and  then added a bit of the Pumice Stone all over the moon. That does not only tone down the yellow but also softens the edges of the craters.
The sky around the moon I created with Distress Ink Fossilized Amber, Crackling Campfire, Fired Brick and Ground Espresso. Well, that looked way too much like a sunset at the beach to me and I added some Black Soot to the mix. Then I splattered some water and also black acrylic paint onto the sky. Now I was finally happy and the sky halloween-ish enough for my taste.
 

 Unten am Boden ist ein kleiner Geist mit seinen beiden Kürbis-Freunden bereit für die große Spuknacht. 
Der süße Geist aus Build-a-Critter More Costumes ist eigentlich ein Kostüm für den Hasen aus Build-a-Bunny, aber ich finde ihn "einfach so" benutzt fast noch süßer.  Ich habe ihn aus hellgrauem Cardstock gestanzt und mit Copics leicht schattiert. Hinter die Ausschnitte für Nase und Augen habe ich grau-braunen Cardstock gesetzt und dann nur die Augen und Nase des Hasen aufgeklebt. Ist das nun ein Hund, ein Bär oder etwas ganz anderes unter dem Kostüm? Das überlasse ich ganz Euch. 
Die beiden Kürbislaternen sind aus dem Set Build-a-Jack-o-Lantern, ebenso wie die herausgeholte Kürbisfüllung samt Löffel und Messer rechts auf der Karte. Und weil die Kürbisse auch so gerne verkleidet sein wollten, habe ich aus einem einen Piraten und aus dem anderen eine Hexe gemacht. Dafür kam dann das Build-a-Critter Costumes Set zum Einsatz, aus dem übrigens auch der Kürbiseimer samt Bonbons ist, den der Geist in den Händen hält. 
Alle Teile sind aus farbigem Cardstock gestanzt und mit Copics schattiert. 
Die Bonbons habe ich aus rotem Glitter-Cardstock gestanzt, die Enden schwarz angemalt und mit einem schwarzen Fineliner auch das eingestanzte Muster, das man im Glitter-Cardstock nicht mehr gesehen hat, nachgemalt. Die Highlights aller Teile sind mit einem weißen Gelstift gemacht. 
Nun fehlte für meine Motive noch ein Boden. Für Halloween passt das natürlich Nebel. Ich habe zwei der Stitched Simply Wavy  Borders aus Vellum gestanzt und je eine vor und hinter die Kürbisse geklebt. Und für eine große Nebelwand dahinter habe ich die Randstanze der Bubble Border aus Vellum gestanzt. Das sah mir dann aber doch zu sehr nach Wolkenwand aus. Also habe ich die Stanze nochmal von unten angelegt und einen großen, fluffigen Nebelschwaden daraus gemacht, der nun hinter den Motiven wabert. So wird auch nicht so viel des Himmels verdeckt.
 
At the bottom of the card a little ghost and his two pumpkin friends are all ready for Halloween night. 
The cute ghost is from Build-a-Critter More Costumes and meant to be used to dress up the bunny from Build-a-Bunny. But I think, it looks even cuter without the bunny behind it. I die cut it from light grey cardstock and shaded him with Copics. Behind the cut outs for the eyes and nose I put some grey-ish brown cardstock and then glued just the eyes and nose of the bunny on top. Is there a dog, a bear or something else under the sheets? I leave that up to you.
The Jack o' lanterns are from Build-a-Jack-O'-Lantern, as well as the pumpkin "guts" and spoon and knife. And since the pumpkins wanted to be dressed up, too, I turned them into a pirate and a witch. For these costumes I used the Build-a-Critter Costumes set. From this is also the pumpkin bucket, that the ghost is holding, and the candy.
I die cut all pieces from colored cardstock and shaded them with Copics.
The candy I cut from red glitter cardstock, colored the ends black and used a black fineliner to draw in the cut in details, that aren't visible very clearly on the glitter cardstock.  The highlights I made with a white gel pen.
Now my images just needed a ground to stand on and for Halloween, some fog is perfect. I die cut two of the Stitched Simply Wavy Borders from Vellum and glued them on top and behind the pumpkins. And for a curtain of mist behind the images I had die cut the edge die from Bubble Border from vellum. But that looked too much like clouds. So I turned the border around and also cut it from the bottom of the vellum to create a large, fluffy piece of fog, that's now behind the images. And it doesn't cover too much of the sky, too.
 

 Oben am Himmel war dann noch Platz für einen Text und eine Fledermaus - die darf an Halloween natürlich auch nicht fehlen!
Die Fledermaus ist aus dem Full Moon Stanzenset. Ich habe den Körper aus grauem Cardstock, die Flügel wieder aus rotem Glitter-Cardstock gestanzt und mit Copics schattiert. Dabei habe ich den Flügeln ein Muster aufgemalt. 
Die Texte auf meiner Karte sind aus Costume Party ("happy Halloween") sowie Tiny Halloween und weiß auf schwarzem Cardstock embosst.
 
In the sky there was room for my text and a bat - a must on any Halloween card.
The bat is from Full Moon. I cut the body from  grey cardstock, the wings from red glitter cardstock and used Copics again to shade them. I also drew on some details onto the wings.
The texts are from Costume Party ("Happy Halloween") and Tiny Halloween and white heat embossed onto black cardstock. 
 

 Ich habe die beiden Kürbisse samt dem Nebel-Boden und die Texte mit dünnem, den Geist und die Fledermaus mit dickem 3D Tape hinterlegt. Zum Schluss habe ich dann alles auf einen weißen Kartenrohling geklebt.
 
I backed the pumpkins with the foggy ground and the texts with thin, the ghost and bat with thick foam tape. Then I adhered the card panel to a white note card.